1979 SSD frame footpeg mounts

mdal · Post by **mdal** » Tue Jul 05, 2011 7:10 pm

Hi All

My frame has been altered along the way by someone to move the footpegs further back. The old mounting bosses have been cut off and a new mount fabricated. In the quest for originality I have removed the new additions and now want to go back to original. I can see where the old mounts were located by the ground off welds. Could someone please measure their mounts and tell me:-
1. The dimensions of the mounts
2. How far they protrude out past the frame.

Thanks Mark

See photos

mdal · Post by **mdal** » Tue Jul 05, 2011 7:18 pm

https://picasaweb.google.com/1173514082 ... directlink[/img]

mizike77 · Post by **mizike77** » Wed Jul 06, 2011 1:45 am

The toothed circle under the swingarm pivot is the factory peg mount. Not sure what the cut off welds are from...

Craig in France · Post by **Craig in France** » Wed Jul 06, 2011 2:04 am

Hi Mark,

3 photos below of what I think you want. In which case, it's 30mm long, 20mm OD. (Sorry, didn't measure the ID but I guess it will be whatever your pegs need ! )

HTH, but if you need more, let me know.

Ciao

Craig

Craig in France · Post by **Craig in France** » Wed Jul 06, 2011 2:27 am

mizike77 wrote:The toothed circle under the swingarm pivot is the factory peg mount.

You might reasonably think so, but that's not actually the case. While you find this knurled fitting on early SSDs like Mike's, it wasn't in fact used for mounting the pegs - or, indeed, anything else

...

(However, I s'pose it WAS used on the SD, tho' - ?)

You can see it here 'Not in Use' on my SSD.

Ciao

Craig

gioto3 · Post by **gioto3** » Wed Jul 06, 2011 1:01 pm

Hi Mark
These are two pics of my footpeg mounts

At the moment I don't have more detailed pics, They seems identical to Craig ones.
If you need any measurements or detailed pics just let me know.
Ciao
Giovanni

mdal · Post by **mdal** » Wed Jul 06, 2011 2:52 pm

Thanks Craig and Giovanni

Can I assume the mount protrudes past the frame by approximately 10mm.
Could you please confirm. See attached drawing.

Mark

https://picasaweb.google.com/1173514082 ... directlink

mizike77 · Post by **mizike77** » Wed Jul 06, 2011 4:44 pm

I thought it was an SD....my mistake!!!

gioto3 · Post by **gioto3** » Thu Jul 07, 2011 12:00 am

Hi Mark,
the total length of the piece is 32 mm and in my bike it protrudes 12 mm from the frame and is oriented on the other side respect to your drawing, have a look at the pic.

Ciao
Giovanni

mdal · Post by **mdal** » Thu Jul 07, 2011 12:52 am

Giovanni

Thanks for that. I have mounts made and now can go ahead and complete welding in position.

Mark

<-=- Club Bevel Heaven -=->

1979 SSD frame footpeg mounts

1979 SSD frame footpeg mounts

Having trouble with photos