Page 1 of 1
cush drive
Posted: Wed Feb 25, 2009 1:22 am
by gavin
i have recently replaced cush rubber,sprocket carrier and have only done around 500k`s and there is play back in it again.chain and sprockets are new as are all rear wheel bearings.if i remove the spacer from between carrier and wheel its nice and snug again. cush drive carrier worn?
Posted: Wed Feb 25, 2009 2:05 am
by garryc
Did you check the tension on the bolts that hold the sprocket to the cush drive, on mine the bolts worked loose elongated the holes allowing the bolts to wobble enough to work loose sufficiently to snap the bolts
Posted: Wed Feb 25, 2009 2:22 am
by gavin
sprocket is tight on carrier,and cush carrier is tight on wheel
Posted: Wed Feb 25, 2009 2:27 am
by Jon
Pull the cush drive apart a give both housings a smear of silicone and re-assemble. Do it on hydraulic pump drive couplings and the likes all the time and they last indefintely, because there is no movement they don't wear out.
regards
jon