<-=- Club Bevel Heaven -=->

Just wondering if any one can help, Im building a 84' S2 from scratch and getting to the wiring part, Q. I have (as shown in the wiring diagram) a couple of "blue-black" wires with bullet type connectors leaving the loom about 1/2 way down, I asume they are connected to the neutral switch, but where? I cant see any other wires from the engine other than the alt and ignition Tom

at my S2 from 83 the neutral switch is sitting outside just behind the sprocket.
In same area here should be an excentric from the gearbox activating the switch.

The switch is located in a approx. Ø12- 15 mm hole in engine case and is held with a M6 screw.

Hope this can help.

Best regards Per

bloody italians, thanks