Page 1 of 1

Conti exhaust clamps are back

Posted: Fri Sep 25, 2009 5:44 pm
by BevelDave
If there are any people looking for some conti exhaust clamps, I just ordered 2 sets from Bevel Rubber (www.bevelrubber.com.au). They have done a small run of both M's and R's, quality is fantastic as usual!
Regards,
Dave.

Posted: Fri Sep 25, 2009 11:40 pm
by rwhc80
Thanks Dave,

I was bidding on a set on Ebay this week but missed out, so probably better that I did. These ones look closer to the original finish as the E-bay ones had been highly chrome polished and I don't believe the originals were like that ?

These things have been hard to find for ages so good to see they're available again. just wish somebody would make a Darmah master cylinder again.

Cheers
Rick