<-=- Club Bevel Heaven -=->

No, I really hadn't thought about anything but a Mikuni really.
Just looked some up on ebay, have to say I've never seen one of these in person. They look like they might be a bit tall. One problem I'm going to have is fitting the carb in between the head and both the frame top tube and the tube ...

I'm building a dirt bound 350. Intake port is 26mm, I'd like to blend this out to 28/30mm and fit a Mikuni. Welcome input on the porting.

Most Mikuni's are jetted for two strokes. Can anyone recommend a source for Mikuni carbs set up at least in the ball park for a 350? Or offer up slide and ...

As mentioned in a couple other posts, I'm going to put a Ducati engine in a Maico chassis. Did this once before. First time I eliminated double down tubes clear back to the lower rear Ducati engine mount. This required a lot of fabricating of new footpeg mounts etc. This time I'd like to keep the ...

I just posted to the classified looking for a 450 engine, then saw this thread.
Back in the mid 70's I put a 350 Ducati engine in a '71 Maico chassis. I set it up for moderate travel suspension. Being as the 350 was street legal, I just swapped the license plate over and keep street riding it ...

I'm looking for a non-desmo 450 single in decent running condition. Need engine electrical (magneto or alternator OK), exhaust, shift and kick start levers, don't need a carb. Must have clear title. A wrecked bike with California plate would be ideal, but just the engine bits listed would be great ...